Package include
Package Include
A. Left piece
B. Right piece
C. Top piece
D. Front piece
E. Rear piece
F. Fan_holder piece
G. Top_holder piece
H. Locker piece
I. Fan
J. Current limit fan board
K. USB 3.0 type A-micro B cable
L. 15V/4A Power Supply
M. 30Pin GPIO Ribbon Cable
N. CloudShell2 Board
O. 2x 10mm Truss Head
P. 4x 10mm Pan Head
Q. 4x 8mm female hex XU4 spacer
R. 8x 5mm Round Head
S. 12x 10mm Round Head
Assembly guide
| 1. | 2. | ||
|---|---|---|---|
 | Screw the left and right pieces to the hard disks. (A + B + S) |  | Attach the Cloudshell-2 board to the hard disks.(N) |
| 3. | 4. | ||
 | Screw the Cloudshell-2 board to left/right pieces. (O) |  | Assemble the FAN and back piece and place the FAN at the back side. Use only 3 screws in this step. (E + I + P) |
| 5. | 6. | ||
 | Insert the FAN cable to the Cloudshell-2 board. |  | If you want to use quiet fan mode, connect the current limit PCB between the FAN cable connector and the Cloudshell-2 board. |
| 7. | 8. | ||
 | Assemble the ODROID-XU4 and XU4 holder pieces. (C + Q + R) |  | Connect micro B side of USB 3.0 cable to the Cloudshell-2 board. (K + N) |
| 9. | 10. | ||
 | Connect GPIO ribbon cable between ODROID-XU4 and Cloudshell-2 board. (M + N) |  | Connect type A side of USB 3.0 cable to ODROID-XU4. |
| 11. | 12. | ||
 | Place the front piece at the front side. (D) |  | Cover the top piece and insert the top_holder on the top . (C + G) |
| 13. | 14. | ||
 | Keep the line on the side to insert the fan_holder. |  | Slide fan_holder piece to fix the top_holder piece on the Fan. (F) |
| 15. | |||
 | Put the locker piece and screw it. (H + P) | ||
john1117