This is an old revision of the document!


Package include

Package Include

A. Left piece
B. Right piece
C. Top piece
D. Front piece
E. Rear piece
F. Top_2 piece
G. Top_3 piece
H. Locker piece
I. Fan
J. Current limit fan board
K. USB 3.0 type A-micro B cable
L. 15V/4A Power Supply
M. 30Pin GPIO Ribbon Cable
N. CloudShell2 Board
O. 2x 10mm Truss Head
P. 4x 10mm Pan Head
Q. 4x 8mm female hex XU4 spacer
R. 8x 5mm Round Head
S. 12x 10mm Round Head

Assembly guide

1. 2.
ASCII Screw the left and right pieces
to the hard disks. (A + B + S)
ASCII Attach the Cloudshell-2 board
to the hard disks.(N)
3. 4.
ASCII Screw cloudshell-2 board
to left/right pieces. (O)
ASCII Assemble the FAN and back piece and
place the FAN at the back side.
Use only 3 screws in this step. (E + I + P)
5. 6.
ASCII Insert the FAN cable
to the cloudshell-2 board.
ASCII If you want to use quiet fan mode,
connect the current limit PCB between
the FAN cable connector and
the Cloudshell-2 board.
7. 8.
ASCII Assemble the ODROID-XU4 and
XU4 holder pieces. (J + M + Q + R)
ASCII Connect micro B side of USB 3.0 cable
to the Cloudshell-2 board. (H + K)
9. 10.
ASCII Connect GPIO ribbon cable
between ODROID-XU4 and
cloudshell-2 board. (F + K)
ASCII Connect type A side of USB 3.0 cable
to ODROID-XU4.
11. 12.
ASCII Place the front piece
at the front side. (C)
ASCII Cover the top piece on the top. (D)
13. 14.
ASCII Put the locker piece and screw it. (I + N) ASCII Cover the top piece on the top. (D)
15.
ASCII Cover the top piece on the top. (D)