common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04 [2020/03/18 12:16]
luke.go [lircd.conf]
common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04 [2020/04/23 16:09] (current)
luke.go ↷ Links adapted because of a move operation
Line 37: Line 37:
  
 Please refer to this link for the whole contents of hardware.conf. \\ Please refer to this link for the whole contents of hardware.conf. \\
-[[internal:common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04#hardwareconf | hardware.conf]]\\+[[common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04#hardwareconf| hardware.conf]]\\
 </WRAP> </WRAP>
  
Line 50: Line 50:
 </code> </code>
 This reference lircd.conf is generated to support Hardkernel IR remote controller.\\ This reference lircd.conf is generated to support Hardkernel IR remote controller.\\
-[[internal:common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04#lircdconf| lircd.conf ]]\\+[[common:application_note:gpio:lirc_gpio_blaster:irblaster_lirc_setup_ubuntu16.04#lircdconf| lircd.conf ]]\\
 https://www.hardkernel.com/shop/ir-remote-controller/ \\ https://www.hardkernel.com/shop/ir-remote-controller/ \\
  
Line 81: Line 81:
  
 <tabbox ODROID-C4> <tabbox ODROID-C4>
-Supposing to use Pin#15 of ODROID-C4 (GPIO #483),+Supposing to use Pin#13 of ODROID-C4 (GPIO #480),
 <code bash target> <code bash target>
 $ service lirc stop $ service lirc stop
 $ modprobe lirc_dev $ modprobe lirc_dev
-$ modprobe lirc_odroid gpio_out_pin=483 softcarrier=1 invert=1+$ modprobe lirc_odroid gpio_out_pin=480 softcarrier=1 invert=1
 (automatically, service lirc will be started) (automatically, service lirc will be started)
 </code> </code>
  
 <tabbox ODROID-C2> <tabbox ODROID-C2>
-Supposing to use Pin#of ODROID-C2 (GPIO #249),+Supposing to use Pin#11 of ODROID-C2 (GPIO #247),
 <code bash target> <code bash target>
 $ service lirc stop $ service lirc stop
 $ modprobe lirc_dev $ modprobe lirc_dev
-$ modprobe lirc_odroid gpio_out_pin=249 softcarrier=1 invert=1+$ modprobe lirc_odroid gpio_out_pin=247 softcarrier=1 invert=1
 (automatically, service lirc will be started) (automatically, service lirc will be started)
 </code> </code>
  • common/application_note/gpio/lirc_gpio_blaster/irblaster_lirc_setup_ubuntu16.04.1584501418.txt.gz
  • Last modified: 2020/03/18 12:16
  • by luke.go