ODROID Factory Test Mode for ODROID-GO Ultra

When you turn on board power while holding down the Trigger Left 1 and Trigger Right 1 buttons at the same time, you can enter ODROID Auto Test mode.

When the recovery splash-screen is displayed, you can release the button.

You will perform the following test modes in sequence.

Battery & Charging Test
LCD Test
Backlight Test
Buttons Test
Analog Joysticks Test
USB Host(A-type) Test
Audio Test
Test complete

To exit the currently running test mode and go to a next test mode, please use the following Test Exit Key Combination.

OGU : F2 + F5 (Most left and Most right gray buttons)

And using long-press PWR KEY, you can power off the system.

The followings will be updated periodically on LCD display until you exit test mode using Test Exit Key Combinations.

Battery Connection

The following information is displayed according to the battery connection.

BATTERY : Connected
BATTERY : Disconnected

If the battery is disconnected, OGU can not turn on the LCD.

USB-C type Power Jack Connection

The following information is displayed according to the connection status of the USB-C type power jack.

DC JACK : Connected
DC JACK : Disconnected

Charging state

The following information is displayed according to the charging status.

CHARGING STATE : DISCHARGING
CHARGING STATE : CHARGING
CHARGING STATE : FULL

Battery Voltage

This shows battery voltage value in V unit.

e.g) BATTERY VOLTAGE : 3.7000 (V)

Charging Current

This shows charging current value in A unit.
If DC Jack is connected & charging is in progress, it's expressed as a POSITIVE value.

e.g) CHARGING CURRENT : 0.7000 (A)

Or, if charging is not in progress, a NEGATIVE value (system current consumption) will be shows,
and it's normal operation.

e.g) CHARGING CURRENT : -0.4200 (A)

LCD color will be changed when you press any button.

Red → Blue → Green → White → black

Backlight level is changed when you press any button.

10% → 30% → 80% → 100%

When you enter this test mode, all buttons layout are shown in Gray color.
The button on LCD will be display in GREEN during you press a button, and then it will be changed to RED color.

For the accuracy of analog joysticks test, calibration is run first.

By pressing a button, calibration will start in 2 seconds.
Please be careful NOT to control analog joysticks during calibration.

Calibration complete.
Press any button to start Analog joysticks test.

When you enter this test mode, you can check the real-time X/Y ADC values of all joysticks graphically.

Displays the connection status to the USB Host. When Device is connected, Product_String or USB_VID is displayed.

USB STATE : DISCONNECT
USB STATE : FLASH DRIVE

When entering Audio Test Mode, a simple beep is played continuously.
And the speaker/headphone output is switched according to the headphone status.
Displays the connection status to the HEADPHONE.